Molded urethane

3.75" x 4" (95 mm x 100 mm)

For Optimum Bonding – 1. Board and stomp should be at room temperature, 70 F [ 21 C ]. 2. Clean surface with rubbing alcohol. Surface must remain clean, smooth and dry. Do not touch. 3. Use a blow dryer on high to heat up the prepared board surface as well as the adhesive on the traction device. 4. Immediately after heating, place the stomp and press firmly. Stand on the stomp pad without twisting, the more weight the better. 5. Allow the adhesive to cure at room temperature for 24 hours.